Broadband-Hamnet™ Forum :: Problems & Answers
Welcome Guest   [Register]  [Login]
 Subject :NanoBridge M2 Cannot save Setup.. 2018-04-17- 21:29:42 
K0BAD
Member
Joined: 2014-04-28- 17:30:15
Posts: 17
Location

I just got ahold of a used NanoBridge M2 and installed the firmware. I cannot get past the setup. When I attempt to save the setup, it responds "error saving setup."


If I intentionally make an error - such as failing to enter a password - it responds with a message that indicates I must enter a password. The generic message is not helpful. Has anybody encountered this before?


I also noted that the device does not have the expected IP address but instead has maintained the default UBIQUITI address.


Should I attempt to re-install the firmware?

IP Logged
Page # 


Powered by ccBoard


SPONSORED AD: