1. could not mesh until in the setup screen i moved the text until the end of :broadbandhamnet-v1:  showed in the window and i saved it

2. power came up as 16db, when i change it to 27, apply and save it shows up as 27; however reboot or turn off and back on results in return to 16

thank you to the creators of this fun and useful software

kyle---kgesswein@comcast.net

1). This actually sounds like it might be an issue more with the browser used and some of the html code and not the fact it is a titanium device.

The other option is there is a known bug in 1.0.1 if you hit apply on an unsupported device it Disables the RF until reboot.

2) 100% expected.  Ubiquiti devices have an RF amplifier chip on board.  It is like setting a ht at 5w with an amplifier. The radio thinks it is only putting out a low power but the amplifier is actually increasing the power and the radio doesn't know about it.  Same thing happens with Ubiquiti devices the software thinks the power is lower than it really is.  We have been programming this in when we make them "supported" devices.

Your device is likely putting out full power in this case.