Hello,

I am sitting on the bench with several units talking to each other.  PicoStation2HP, Rocket M2, and a NanoStation loco M2.  Every thing is so close that I would expect and do read 100% under Mesh Status/Current Neighbors/ LQ.  Every thing except the loco unit it reads ~89%.  Don't fully understand.  I signed into the loco unit, under SETUP/BasicInformation/WiFi/active settings list and the the RX and TX antenna pull downs show up as "N Connector" and can not be changed.  I can see that this would hold true if I was working with a UBNT Bullet, but I am not, its a loco.

Yes I did do the proper factory flash with the proper software.  Does any body have any idea what is going on?

Thank you.

Paul Strauss

WD6EBY

Output of 

 cat /sys/devices/pci0000:00/0000:00:00.0/subsystem_device

On the node please.

Have you modified any files on the node itself ? 

Hi Conrad,

I have NOT modified any of the code.  The only parameters that I have changed are those vi the WWW interface. 

BTW the number I left on your answering machine, call anytime from 9 am to 9 pm.

THX Conrad

Paul Strauss

WD6EBY